Post by hb3yyf on Nov 23, 2010 3:56:45 GMT -5
Hi
I bought about 3 months before a Yaesu FT 7800 and now have the following problem:
I was just entered the the frequencies and memory banks when I realized that I had forgotten one frequency. It only instead of all this I decided to reset the device.
So I put everything back to manual. The device reset ended and switched off. In the manual is, however, that the unit off and then turning it back would have. Since it does not work for me intervened, I pressed the "power button". The unit would not take more.
I turned off the power supply and on. Although I began the unit touched it to be felt, where there were the usual Einschalttöne of itself. The display however seemed nothing and the backlight is off.
When I removed the screen and followed the stream, it does not turn on. I then added to the display and pressed the power button. Also there was the device sounds. The display did not appear again and the backlight is off.
Finally, I tried again to remove the display before starting and then press the power button nor the MHz / PRI key for a reset. Again, this only worked halfway. The device was then reset the tone of the (start-up sound with an additional sound), but nothing appeared on the display and the display is off. Next select functions such as not worked with Reset Mode knob.
I tried everything until now. Does anyone have a solution? This is because the software (a new device will not hurt not have one)?
please excuse my English. I hope you still understand my question.
I bought about 3 months before a Yaesu FT 7800 and now have the following problem:
I was just entered the the frequencies and memory banks when I realized that I had forgotten one frequency. It only instead of all this I decided to reset the device.
So I put everything back to manual. The device reset ended and switched off. In the manual is, however, that the unit off and then turning it back would have. Since it does not work for me intervened, I pressed the "power button". The unit would not take more.
I turned off the power supply and on. Although I began the unit touched it to be felt, where there were the usual Einschalttöne of itself. The display however seemed nothing and the backlight is off.
When I removed the screen and followed the stream, it does not turn on. I then added to the display and pressed the power button. Also there was the device sounds. The display did not appear again and the backlight is off.
Finally, I tried again to remove the display before starting and then press the power button nor the MHz / PRI key for a reset. Again, this only worked halfway. The device was then reset the tone of the (start-up sound with an additional sound), but nothing appeared on the display and the display is off. Next select functions such as not worked with Reset Mode knob.
I tried everything until now. Does anyone have a solution? This is because the software (a new device will not hurt not have one)?
please excuse my English. I hope you still understand my question.